Replacing a Decoder (Full Walkthrough)

This walkthrough will demonstrate the following in order:

• Add a new decoder to the controller
• Edit an existing station to add this decoder
• Delete the old decoder

1. Follow the relevant walkthrough below to add the new decoder to the controller:
   1. LD Decoder
   2. NG Decoder
2. Navigate to   → Irrigation controller → Stations
3. Find the station you wish to assign the decoder to
4. Click
5. Under the IO dropdown, search for the decoder address you wish to add
6. Click SAVE
7. Navigate to   → 2-Wire → Decoders
8. Find the address of the decoder you wish to delete
9. Click
10. Click   (if the decoder is still assigned to a station, it cannot be deleted)