Adding an RKLD-050 to the NLP

Note: The NLP has no capability of programming RKLD-050 decoders. Decoders will need to be preprogrammed to the correct station, or an existing RKD/RKD+ or HCP handheld programmer will need to be used. Tucor recommends utilizing the NG series of decoders with NLP controllers.

1. Navigate to   → 2-Wire → Decoder
2. Click   
3. Under type, select tucor rk
4. Under Address, enter 100 followed by the station number
5. Set input as 0
6. Set outputs as 1
7. Click CREATE

If you are following "Replacing a Decoder (Full Walkthrough), use this link:

Replacing a Decoder (Full Walkthrough)